Ideal nails to use on cedar wood are made from aluminum, double-dipped galvanized, or stainless steel. Other types of nails such as plain steel nails are not advisable because reactions between the nails and the siding and the environment will create ugly stains on your siding over time.
Where do you nail cedar shingles?
Place two nails 2 cm (3/4 in.) from each edge of the cedar shingle and 4 cm (1 1/2 in.) above the exposure. To avoid buckling, allow 3 to 6 mm (1/8 to 1/4 in.)
Can you use a brad nailer for cedar shingles?
A regular brad nailer? … That will make our task easy as we will only need to identify a nail gun that shoots the accepted nails.. Now, here is what the CSSB says about fasteners for cedar shingles: “Use either rust-resistant staples or shingle nails (1-1/4” to 1-1/2” long), galvanized, in stainless steel or aluminum”.
Can you use roofing nails for cedar shakes?
Some nail manufacturers offer nails specifically for wood shake or shingle roof application. … The Cedar Shake & Shingle Bureau prefers the use of nails, however if you choose to use staples they must be stainless steel Type 316 in locations within fifteen (15) miles of salt water.
How do you keep cedar shingles from turning GREY?
To prevent cedar from fading to gray, you need to seal cedar fence with a stain that blocks ultraviolet light and contains a mildewcide, according to Family Handyman.
Is it better to nail or staple shingles?
Fasteners for asphalt shingles should be roofing nails or staples. The head of a roofing nail or the crown of a staple is what actually holds a shingle in place. … If staples are properly installed, they offer nearly the same wind resistance as nails. The problem with staples is the orientation of the staple crown.
How much do you overlap cedar shingles?
Leave a gap of approximately 1/8” to 1/4” (0.3 to 0.6 cm) between neighboring shingles to allow for expansion due to moisture. Joints of successive courses must always be offset by at least 1 1/2” (3.8 cm) to prevent water build-up. Treat shingle imperfections the same way.
How do you nail cedar clapboards?
Bevel siding should be face nailed to studs with 1-1/4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center. Place nail just above the overlap. Take care not to nail through the overlap of two pieces.
How many nails are in a square of cedar shingles?
The standard required amount of nails for cedar shingles is 320 pieces per square. For areas with a lot of wind, six nails for each shingle might be needed, which means you need 480 nails for each square.
What is the purpose of cedar breather?
Cedar Breather® protects the beauty and life of wood roofing by providing a space for continuous airflow between the solid roof deck and shingles or shakes.