At the side, or gabels, of a roof, the drip edge goes over the roofing felt. At the bottom of the roof, the drip edge goes under the roofing felt.
Where does drip edge go on a roof?
Drip edge is installed around the whole perimeter of the roof. It is used to hold the underlayments down and create a watertight seal around the edge of the roof. Only the face of the metal is seen and is usually just white one to one and half inch stripe located right under the shingles and above the fascia.
Does drip edge go around entire roof?
The correct placement of a roof drip edge is on top of the roof’s exterior cover directly between the sheathing and the fascia board, which forms a drainage gap between the drip edge and the fascia board. As a result, the drainage improves water flow and protects the roof from potential water damage.
How far should shingles overhang drip edge?
Asphalt shingles should overhang the exterior edge of the drip edge by ¼ to ¾-inch. Check local building code for drip edge requirements prior to the start of your roofing project.
Do you nail or staple roofing felt?
Some roofers prefer to attach felt underlayment with 1-inch roofing nails or special nails with plastic washers, but most codes allow staples, which are easier to drive.
Do gutters go under or over drip edge?
It is recommended that gutters are placed under or ‘behind’ the drip edge of your roof. A drip edge refers to a component that hangs over the roof and has an outward projecting lower edge.
What is the underside of a roof overhang called?
The underside of this overhang, when given a finished appearance, is known as the soffit, which means “something fixed underneath”. The soffit is basically, any finishing material, such as wood or fiber cement, that is installed to cover the underside of your roof overhang.
What is the purpose of drip edge on a roof?
Drip edge is a metal flashing that is installed at the edges of the roof to help control the flow of water away from the fascia and to protect the underlying roofing components.
What is the difference between drip edge and rake edge?
Drip edge and rake edge are the first parts of the roof system to be installed. They form a long, narrow piece of metal, which is installed along the perimeter your Roof Deck. Drip edge goes along your eaves trough areas and rake edge goes along your gable ends.
How much does drip edge cost?
Drip Edges: $1-$2 per linear foot installed. Drip edges are added to the roof to direct water into the gutters. Other Damage – Have a professional inspect your eaves for damage before repairing fascia and soffits.
How far should gutters be above drip edge?
MISTAKE #4 – Improperly Locating the Gutter
When choosing gutters, consider the material, as well as the size and width needed. Your gutter needs to be a few inches under the edge of your roof.
How should drip edge be installed?
Place the drip edge down, aligning it so water will drip into the gutters. The end with the flange or flare should point down and away from the roof. Step Three: Use roofing nails to secure the drip edge. Nail high up on the drip edge so that the shingles will cover the nails.
Should drip edge be tight to fascia?
Nail thefurring strip to the fascia board near the fascia top – tight under any extending of roof decking (usually absent); the Drip edge will be installed 1/8″ proud of (away or out from) the furring strip in best practice or may be installed tight against the furring strip (reduces the life of the furring strip by …
Do I need drip edge on shed?
Your shed should be built to withstand the elements. That means repelling water in the most efficient way possible. Installing drip edge around the perimeter of the shed is the best way to keep water out and away from your shed.