The quick answer is yes you can re-roof architectural shingles over existing architectural shingles (however you must check with the shingle manufacturer as well). Having said that it will be nearly impossible to get a good looking quality installation.
Can you put a second layer of architectural shingles on a roof?
Yes you can install a second layer of shingles over the existing layer of shingles. I would recommend that you remove any step flashing or vents and pipe stacks to make sure that they have no damage from previous installation.
Can you put 3 tab shingles over architectural shingles?
In most cases, you can apply a second layer of three-tab shingles over an existing roof that features three-tab shingles without having to tear off the existing roof. However, you cannot apply three-tab shingles over architectural shingles.
Can you put roof shingles over existing shingles?
The answer is yes, you can lay new roof shingles over old ones. … You can’t do it with wood or slate, for example, and you should never mix materials, such as laying asphalt shingles over cedar shakes. Also, the old roofing has to be in pretty good condition.
Should you remove old shingles before installing new shingles?
While a repair job can often be more convenient and somewhat more cost-efficient, placing new shingles over old ones is never a good idea. Whether repairing one section of roof, or a replacing a whole one, it’s always best to pull up the old shingles before putting down the new ones.
How long do architectural shingles last?
Lifespan. Because of their durability and high-quality composition, architectural shingles generally have a longer lifespan than the 3-tab variety. They stand up better to weather conditions such as heat, snow, ice, rain, and strong winds. Their average lifespan is about 18 to 20 years.
What is the price difference between 3 tab shingles and architectural?
When it comes to cost, architectural shingles typically runs $35 to $45 per bundle. Three-tab shingles cost an average of $25 to $30 per bundle. On the surface, the architectural shingles are 40 to 50 percent more expensive.
Where do you nail shingles architectural?
A minimum of four nails are required per shingle, located in the sealant line about 6 inches up from the bottom edge of the shingle. One nail should be placed approximately 1 inch from each side of the shingle, and the remaining nails equally spaced between the two outer nails.
What is the advantage of architectural shingles?
Architectural asphalt shingles are thicker and stronger. They have more weight which makes them less likely to move or fall off even in higher winds. Their extra thickness also makes them harder to damage. This kind of roof is simply more durable and will last longer.
Is it OK to put metal roofing over shingles?
In almost every case, the answer is yes, you can lay down a new metal roof over an existing shingle roof. This is one of the many reasons metal roofs keep growing in popularity – their installation doesn’t require completely tearing off the existing roof, which is a time-consuming and expensive job.
Does flashing go over or under shingles?
Instead of installing the step flashing between shingles, the flashing rests on top of the shingles. It’s not unusual to see sealant installed when sidewall flashing is missing. Sealant will eventually dry, shrink and crack. You’ll see sealant substituted for flashing in a lot of different areas on roofs.
Will black shingles make house hotter?
Black and dark-colored roofs.
In general, dark-colored roofing materials will absorb the heat and cause your attic and/or the top of your house to be warmer than a lighter colored material.
How many times can you shingle over a roof?
Depending on the type of roof material used, the number of layers added to a roof range from two to three times. House roofs should never exceed three layers of shingles. Adding additional layers without excavation can save homeowners up to $1,000 in labor.
How do you know when to replace roof shingles?
8 Potential Signs That Your Roof May Need To Be Replaced:
- Shingle edges are curled or shingle tabs are cupped.
- Bald spots where granules are missing.
- Cracked shingles.
- Your roof is at least 20 years old; while many shingles today are produced for durability, many factors can accelerate the aging of shingles. …
- The roof just looks old and worn.
- Neighbors are getting new roofs.