A staggered installation, achieved when using flat concrete roof tiles, is a great way to enhance any home’s exterior and curb appeal. … The stagger of tile, adds striking dimension to your roof and provides a stunning look that is sure to set your home apart from the rest.
Why do you have to stagger shingles?
Known in the trade as “vertical racking” or “staggering,” this how to lay shingles method enables the roofer to install a single column of shingles all the way to the peak, without the wasted back-and-forth motion necessary to fill several rows of stair steps.
How much should Roof tiles overlap?
This is normally specified with the tile manufacturer and it’s advisable to check how much they say a roof tile should overlap, normally on a smooth faced tile the overlap is 75mm (3″) and on granular or sandfaced tiles its 100mm (4″) however if the roof is shallow pitched, is facing a windy direction or will be prone …
Do all roof tiles need to be nailed down?
Every tile along the eaves, up verges and along the ridge should be nailed, but otherwise only nail every fifth tile horizontally, and every third tile up the roof.
How many inches do you stagger shingles?
For ease of installation some roofers install shingles straight up the roof, staggering shingles 6 inches or 18 inches back and forth (Figure 2-9). Since this lines up the shingle butt joints every other course, this is considered a less watertight roof and may leak.
Why is racking shingles bad?
If the racking method has been used, shingle joints align every other course, which increases the chance for roof leakage. … During cold-weather installation, lifting shingle tabs to install the missing nails may crack or crease them. Racking can sometimes result in improper color blending.
How far below roof tiles should Gutter be?
The bottom tile or slate of the roof covering should project at least half way into the gutter – the ideal distance is between half way and two thirds of the way over.
What do roof tiles sit on?
Roof tiles are ‘hung’ from the framework of a roof by fixing them with nails. The tiles are usually hung in parallel rows, with each row overlapping the row below it to exclude rainwater and to cover the nails that hold the row below.
How far apart should roof battens be?
Each product has different requirements, for example, batten spacing for (0.42BMT) corrugated metal roofing needs to be no more than 1100 mm apart, but batten spacing for 0.48BMT metal roofing can be up to 1600 mm apart.
Can roof tiles be screwed?
Generally, roof tile mechanical fixings are a nail or screw at the tile head and a clip at the tail. BS 5534 allows the use of suitable adhesive as a second fix where it is not possible to use two mechanical fixings.
Are clay roof tiles nailed down?
All roofs require a sturdy base layer, but clay tiles need an especially heavy-duty base. Most commonly this is 3/4-inch exterior-grade plywood that is nailed down onto the roof trusses.
Do you nail interlocking tiles?
It is not necessary (nor desirable) to nail every single tile – nailing as described here will provide a fully functional roof while allowing individual tiles to be remove later if necessary.
How do roof tiles keep water out?
Tiles and slates are laid in a way that controls the flow of water down the roof and prevents water from leaking through the junctions between the tiles. Many roof tiles have interlocks formed on their left edge which are essentially water gutters designed to aid this process.
What nails do you use for roof tiles?
Copper nails are most commonly used to fix slates on pitched roofs, but can also be used to secure roofing tiles in place. Copper is also used to create slate straps, which are used on slate roofs to hold broken slates in place, either as a temporary fix or a more long term solution.
How long does it take to tile a roof?
Generally, a roof job should take between 1 and 3 days.